Quality Testing

Quality is delighting customers

Hi All,


In Jmeter While doing sever monitoring, monitor window shows result dead

These are step i did to for server monitoring in Jmeter



1. The first step is to add a Thread Group element.

The Thread Group tells JMeter the number of threads you want. Always use 1, since we are using JMeter as a monitor. This is very important for those not familiar with server monitors. As a general rule, using multiple threads for a single server is bad and can create significant stress.

Change the loop count to forever (or some large number) so that enough samples are generated.

2. Add the HTTP Authorization Manager to the Thread Group element (Add –> Config element –> HTTP Authorization Manager). Enter the username and password for your webserver. Important note: the monitor only works with Tomcat5 build 5.0.19 and newer.

1.       leave the base URL blank

2.       enter the username

3.       enter the password

3. Add the HTTP Request to the Thread Group element (Add –> Sampler –> HTTP Request). Then, select the HTTP Request element in the tree and edit the following properties):

1.       Change the Name field to “Server Status”.

2.       Enter the IP address or Hostname

3.       Enter the port number

4.       Set the Path field to “/manager/status” if you’re using Tomcat.

5.       Add a request parameter named “XML” in uppercase. Give it a value of “true” in lowercase.

6.       Check “Use as Monitor” at the bottom of the sampler

4. Add a Constant timer to this thread group (Add –> Timer –> Constant Timer). Enter 5000 milliseconds in the “Thread Delay” box. In general, using intervals shorter than 5 seconds will add stress to your server. Find out what is an acceptable interval before you deploy the monitor in your production environment.


Pls advice

Thanks in Advance

Views: 871

Reply to This

TTWT Magazine





© 2021   Created by Quality Testing.   Powered by

Badges  |  Report an Issue  |  Terms of Service